The operator ought to strictly follow the protection rules and operations of bending machines. as found in abnormal operation. the operation ought to be stopped straight off. stop checking reasons. Bending machine safety operation is as follows:
1.Strictly abide by the machine work safety rules. per the provisions Wear protecting instrumentation.
2.Before turning on ought to lower mildew cleanup. wipe clean.
3.Check the receptacle rack. gear rack and therefore the presence of foreign matter on the slider. if the foreign body ought to be clean.
4.Before bending. ought to change the gap between the higher and lower molds uniform.
5.Once the device starts loafing for 1-2 minutes on a skateboard full stroke motion 2-3 times. if there's abnormal sound or failure ought to be straight off stopped. the troubleshooting. everything is traditional solely once work.
6.Once quite one person work ought to be unity of command. in order that the operator and therefore the feed suppress closely with workers to confirm that workers area unit issued with folded signals area unit allowed in a very safe location.
7.Once the sheet bending should be compacted to stop bending sheet tilt once hurt.
8.Per the thickness of the folded sheet. choose the suitable die. die size is usually adequate to or larger than eight times the sheet thickness.
9.Piece of work or die throughout the operation found errors ought to stop correction. the correction is prohibited operational to stop hand injury hand.
10.Prohibiting off thick iron or steel quench fireplace. high steel. sq. steel and sheet bending machine performance over the sheet. so as to avoid harm to the machine.
11.When bent. don't place your hands between the mildew. slender tiny material unavailable hand. One will solely bend a bit of fabric. sub-section doesn't bend at a similar time variety of blocks.
12.Bent sheet ought to be placed within the middle of the mildew. the machine shouldn't be unilateral load. thus as to not have an effect on the accuracy of the piece of work and therefore the machine. like once some piece of labor is actually necessary unilateral. it shall not exceed the nominal load of 1/4. and therefore the 2 sides should whereas bending.
13.Once the machine is functioning. the machine isn't allowed to square on the rear.
14.Check the oil tank. begin the pump to examine the hydraulic pipes. pumps while not exception.
15.The exception happens straight off clean up. check the explanation and straight off removed. If you expertise issues once they can't solve once we should raise professionals to repair. should not blind operation.
16.Before movement down. i would like to place wood on the perimeters of the fuel tank below the mildew on the lowest of the sink to the wood or to prevent the slide within the bottom (lower mildew inside). thus as to not hurt the decline since the mechanism issues.
17.The duty is finished. put off the pump and exit system procedures. bring to a halt the ability.