Fault: the slider and therefore the guide rail gap is simply too massive, creating associate uncommon sound.
Such failure is because of the rail employing a lasting, the gap will increase by abrasion. You wish to ascertain the guide plate wear, counting on the degree of damage to work out whether to exchange the rail plate, adjusted to satisfy the necessities of the gap.
Failure II: back gauge drive failure. Back gauge drive failures area unit because of drive shaft spline toothed pulley-block or a temporal arrangement belt from slippy.
Such failures have to be compelled to assemble an honest spline and synchronous belts, and checking the electrical elements.
Failure three: back gauge beam linear guide parallel to the center line of the mound an excessive amount of deviation such failures have to be compelled to unleash the shaft temporal arrangement belt, go with the inner similarity tolerances on the device temporal arrangement belt.
Fault IV: cylinder with the slider loose connections, or allowed causing bending angle the machine can't notice a reference.
Such failures have to be compelled to check and tighten the slider and therefore the cylinder connecting not bending machine tooling troubleshooting Symptom: boot noise, a lot of noise once ironed.
a. Hydraulic oil on top of the minimum level, inflicting the pump exhausted. Add hydraulic oil to traditional.
b. filter obstructive, clean the filter.
c. pump harm.
2. The bending machine isn't solely consequent quick beneath the work into traditional, and there's pressure.
a. poppet stuck, inflicting the come trip stress-free. Cleansing the poppet.
b. pressure is simply too tiny, it can't rise. Increasing the pressure.
c. come is on, however terribly slowly. This failure is because of the filling valve failed to open. Finding fault.
Hydraulic bending machine maintenance:
Torsion synchronous bending machine folding angle on either side of inconsistency?
Cause: The contour isn't constant on either side.
Adjustment: one. Place a plate on both sides of constant thickness, bigger than ninety degrees off the piece of work, victimization foot angle live angle.
2. Connect bending machine tooling high 2 worm rod holders disengaged. Specifically propulsion to 1 aspect. There area unit spring, to forestall break.
3. Compare the 2 plate angles. If on the proper angle, the gyration of the link to the proper. When a little turned a precise position, flap measuring.
4. Repeat the third step till either side are angle. Put in link.
5. Put in at associate angle to do break the link exchange. Look angles area unit constant.
If the angle continues to be inconsistent, read synchronization mechanism is broken, like rod at slip, worm harm.